1) The Torq'N Seal Condenser Plug you have selected from the attached literature should NOT fit into the condenser tube until the expansion screw is used to reduce the plug diameter.

Click on image above for enlargement

2) Remove the end cap by turning to the right. Insert a slotted screwdriver into the expansion screw and turn to the left which will reduce the diameter until the plug fits into the tube ID.

3) Be sure to wipe the tube ID with a clean cloth so it is dry prior to installation of the plug to ensure a good friction fit.

4) Insert the Torq'N Seal Condenser Plug into the tube with the flange pressing against the tube sheet. Tighten the expansion screw to the right until the plug is seated as tightly as possible without stripping the slotted head. Replace the protective end cap onto the expansion screw by turning to the left. 

LOW PRESSURE CONDENSER PLUGS

HOW IT WORKS		HOW IT'S USED
CAP MUST BE REMOVED TO ACCESS ADJUSTING SCREW		REMOVE CAP BY TURNING TO THE RIGHT
SCREW INCREASES BODY LENGTH REDUCING BODY DIAMETER		TURN ADJUSTING SCREW TO THE LEFT
REDUCED BODY DIAMETER ALLOWS PLUG TO BE INSERTED FREELY		INSERT INTO TUBE THEN TURN ADJUSTING SCREW TO THE RIGHT
CAP PROTECTS ADJUSTING SCREW		REPLACE CAP BY TURNING TO THE LEFT